No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RM_1.3.6.1.4.1.2011.5.25.145.19.1.1 hwPublicIpv4PrefixExceed

RM_1.3.6.1.4.1.2011.5.25.145.19.1.1 hwPublicIpv4PrefixExceed

Description

RM/2/PUBLIC_IPV4_PREFIX_EXCEED:OID [oid] The number of public IPv4 prefixes exceeded the maximum value. (PrefixCount=[Integer], MaxValue=[Integer])

The number of IPv4 public route prefixes exceeded that supported by the system.

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.4.1.2011.5.25.145.19.1.1

Major

qualityOfServiceAlarm(3)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

PrefixCount

Indicates the number of IPv4 public route prefixes in the routing table.

MaxValue

Indicates the maximum number of IPv4 public route prefixes supported by the device.

Impact on the System

New IPv4 public route prefixes cannot be added to the routing table. Services will be affected if the number of IPv4 route prefixes keeps increasing.

Possible Causes

Cause 1:

A large number of IPv4 dynamic protocol routes (BGP or IGP routes for example), static routes, direct routes, or UNR routes were added to the routing table.

Cause 2:

The maximum number of IPv4 public route prefixes supported by the system was decreased.

Procedure

  1. Run the display ip routing-table statistics command to check the number of IPv4 public route prefixes and the number of routes of each protocol that are added to the routing table. Run the display ip routing-table limit command to check the number of IPv4 public route prefixes supported by the system.

    Check whether services need these routes or whether the routes are added to the routing table due to incorrect configurations.
    • If the routes are added to the routing table due to incorrect configurations, go to 2.

    • If services need these routes, replace the license or contact technical support personnel for specification expansion.

  2. Adjust the configurations to delete unneeded routes, and check whether the RM_1.3.6.1.4.1.2011.5.25.145.19.1.2 hwPublicIpv4PrefixExceedClear alarm is generated.

  3. Collect alarm information and configuration information, and then contact technical support personnel.
  4. End.
Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141873

Views: 125516

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next