No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SECE_1.3.6.1.4.1.2011.5.25.165.2.2.3.1 hwIPSGDropALarm

SECE_1.3.6.1.4.1.2011.5.25.165.2.2.3.1 hwIPSGDropALarm

Description

SECE/4/IPSG_DROP_ALARM:OID [oid] The packet number dropped by IPSG reaches [INTEGER1], exceed the alarm threshold [INTEGER2], interface [OCTET].

The number of packets discarded by IPSG exceeded the alarm threshold.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.165.2.2.3.1 Warning equipmentAlarm(5)

Parameters

Name Meaning
oid Indicates the ID of the MIB object.
INTEGER1 Indicates the number of discarded packets.
INTEGER2 Indicates the alarm threshold.
OCTET Indicates the source interface, VLAN, source MAC address, and source IP address of packets.

Impact on the System

If this alarm is generated, the device may be attacked. If the attack traffic volume is heavy, the device is busy processing attack packets. As a result, services of authorized users are interrupted.

Possible Causes

The number of packets discarded by IPSG exceeded the alarm threshold.

Procedure

  1. Find the interface where attacks occur according to the value of Interface in the alarm message.
  2. Check whether users who are not in the DHCP snooping binding table range are connected.
  3. If new users are connected, run related DHCP snooping commands to generate the DHCP snooping binding table.

Related Information

None

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141873

Views: 125478

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next