No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RRPP_1.3.6.1.4.1.2011.5.25.113.4.3 hwRrppMultiMaster

RRPP_1.3.6.1.4.1.2011.5.25.113.4.3 hwRrppMultiMaster

Description

RRPP/2/MULMAST:OID [oid] A conflicting master node was detected on RRPP domain [domain-id] ring [ring-id].

The RRPP ring had more than one master node.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.113.4.3 Major processingErrorAlarm(4)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

domain-id

Indicates the ID of an RRPP domain.

ring-id

Indicates the ID of an RRPP ring.

Impact on the System

The configuration is incorrect. The RRPP ring will fail if it has multiple master nodes.

Possible Causes

The RRPP ring had more than one master node. As a result, service traffic is interrupted.

Procedure

  1. Run the display rrpp verbose domain domain-id command to check whether multiple master nodes exist on the RRPP ring.

    • If so, go to Step 2.

    • If not, go to Step 3.

  2. Update configurations of the devices that should not be configured as master nodes as follows:

    1. Run the undo ring ringid enable command and then the undo ring ringid command to delete configurations of the devices that should not be configured as master nodes. Where, the ringid is the ID of the RRPP ring that has error master nodes.

    2. Run the ring ringid node-mode command to reconfigure the master node as required.

    3. Run the ring ringid enable command to re-activate the RRPP loop.

    After the preceding configurations are complete, check whether the alarm is cleared.
    • If so, go to Step 4.

    • If not, go to Step 3.

  3. Collect alarm information and configuration information, and then contact technical support personnel.
  4. End.

Related Information

None

Translation
Download
Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 155449

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next