No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
FSP_1.3.6.1.4.1.2011.5.25.183.1.22.4 hwStackSwitchOver

FSP_1.3.6.1.4.1.2011.5.25.183.1.22.4 hwStackSwitchOver

Description

FSP/4/STACK_SWITCHOVER: OID [oid] After switchover, slot [integer] is selected as master.

This alarm was generated when the original standby switch became the master switch.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.183.1.22.4 Warning equipmentAlarm(5)

Parameters

Name Meaning
[OID] Indicates the OID of the MIB.
[integer] Indicates the stack ID of the device generating the alarm.

Impact on the System

When the standby switch becomes the master switch to replace the faulty original master switch, the device needs to refresh entries, which interrupts services.

Possible Causes

1. The master switch was powered off and left the stack system.

2. The stack cable connecting the master switch was loosened.

3. The active/standby switchover was manually performed.

Procedure

  1. Check whether the active/standby switchover was manually performed using the slave switchover command.

    • If so, this alarm is informational only, and no action is required.
    • If not, go to step 2.

  2. Check whether the original master switch was powered off.

    • If so, power on it. The alarm handling ends.
    • If not, go to step 3.

  3. Check whether the stack cable of the original master switch is loose.

    • If so, install the stack cable securely. The alarm handling ends.
    • If not, collect alarm information and configuration information, and then contact technical support personnel.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141873

Views: 126230

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next