No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
FSP_1.3.6.1.4.1.2011.5.25.183.1.22.2 hwStackLinkDown

FSP_1.3.6.1.4.1.2011.5.25.183.1.22.2 hwStackLinkDown

Description

FSP/3/STACKPORT_DOWN: OID [oid] Stack-port [integer]/[integer] changes to down.

This alarm was sent to the NMS by the master switch when the logical stack port of a switch in the stack system was Down.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.183.1.22.2 Minor equipmentAlarm(5)

Parameters

Name Meaning
[OID] OID of the MIB.
[integer] Stack ID of the device generating the alarm.
[integer] ID of the logical stack port whose status changes on the device. This ID starts from 0.

Impact on the System

If the previous stack system is in a ring topology and the interface in the Down state just functions as the ring-breaking point, the topology may become a link topology. Services, however, are not affected. If the logical stack port in the Down state does not function as the ring-breaking point, the stack system refreshes the forwarding entries. In this case, services are transiently interrupted and automatically recover after the forwarding entries are refreshed.

If the previous stack system is in a link topology, services on the switch that is Down are interrupted and cannot recover until the switch is added to the stack system again.

Possible Causes

1. The switch in the stack system was powered off.

2. The stack cable was connected loosely or even removed.

Procedure

  1. Check whether the switch was powered off.

    • If it was powered off, power on it. The alarm handling ends.

    • If not, go to step 2.

  2. Run the display stack port command to check whether physical member ports are Up.

    • If so, collect alarm information and configuration information, and then contact technical support personnel.

    • If not, rectify the fault according to An Ethernet Interface Is Physically Down.

Related Information

None

Translation
Download
Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 157155

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next