No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
EOAM1AG_1. hwDot1agCfmUnexpectedMEGLevel

EOAM1AG_1. hwDot1agCfmUnexpectedMEGLevel


EOAM1AG/1/UNEXPECTEDMEGLEVEL: OID [oid] MEP received a CCM with unexpected MEG level. (MdIndex=[GAUGE], MaIndex=[GAUGE], MdName=[STRING], MaName=[STRING], MepId=[INTEGER])

The MD level carried in a CCM sent by the RMEP was different from that specified on the MEP.


Alarm ID Alarm Severity Alarm Type Critical communicationsAlarm(2)


Name Meaning


Indicates the MIB object ID of the alarm.


Index of an MD table


Index of an MA table


Name of an MD


Name of an MA


ID of a MEP

Impact on the System

CFM will fail.

Possible Causes

The MD level carried in a CCM sent by the RMEP was different from that specified on the MEP.


  1. Run the display cfm mep [ md md-name [ ma ma-name [ mep-id mep-id ] ] ] command on both the MEP and RMEP to view the value of the Level field. Check whether the MD levels are the same.

    • If the MD levels are different, go to Step 2.

    • If the MD levels are the same, go to Step 3.

  2. Perform the following steps on the MEP:
    1. Run the undo cfm md name md-name command to delete existing MD configurations.
    2. Run the cfm md md-name level level command to reconfigure an MD the same as that on the RMEP.
    3. Run the display alarm active command to view the trap. Check whether the trap is cleared. If the trap persists, go to Step 3.
  3. Collect alarm information and configuration information, and then contact technical support personnel.
Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 156228

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next