No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
FSP_1.3.6.1.4.1.2011.5.25.183.1.22.3 hwStackStandbyChange

FSP_1.3.6.1.4.1.2011.5.25.183.1.22.3 hwStackStandbyChange

Description

FSP/4/STANDBY_CHANGE: OID [oid] Slot [integer] is designated as standby.

This alarm was generated when a slave switch was elected as the standby switch.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.183.1.22.3 Warning equipmentAlarm(5)

Parameters

Name Meaning
[OID] Indicates the OID of the MIB.
[integer] Indicates the stack ID of the device generating the alarm.

Impact on the System

Services on the original standby switch are interrupted and cannot recover until the switch is added to the stack system again.

Possible Causes

1. Once a new stack system was created, a slave switch was elected as the standby switch.

2. The original standby switch left the stack system if the switch was powered off or the stack cable was loosened or manually removed. In this case, a new standby switch was elected.

Procedure

  1. Check whether the stack system was just set up and the standby switch was elected.

    • If so, this alarm is informational only, and no action is required.
    • If not, go to step 2.

  2. Check whether the switch was powered off.

    • If it was powered off, power on it. The alarm handling ends.

    • If not, go to step 3.

  3. Run the display stack port command to check whether physical member ports are Up.

    • If so, collect alarm information and configuration information, and then contact technical support personnel.

    • If not, rectify the fault according to An Ethernet Interface Is Physically Down.

Translation
Download
Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 157143

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next