No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MSTP_1.3.6.1.4.1.2011.5.25.42.4.2.18 hwMstpProNewPortStateForwarding

MSTP_1.3.6.1.4.1.2011.5.25.42.4.2.18 hwMstpProNewPortStateForwarding

Description

MSTP/4/PROPFWD:OID [oid] The MSTP Process's Port has been set to forwarding state. (ProcessID=[INTEGER], InstanceID=[INTEGER], PortID1=[INTEGER], PortID2=[INTEGER], PortID3=[INTEGER], PortID4=[INTEGER], PortIDFlag=[INTEGER], IfIndex=[INTEGER], PortState=[INTEGER], PortName=[STRING])

The link status of MSTP process changed, and the port enters the forwarding state.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.42.4.2.18 Warning communicationsAlarm(2)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

ProcessID

Indicates the MSTP process ID

InstanceID

Indicates the instance ID.

PortID1

Indicates ID 1 of the port in the MSTP process.

PortID2

Indicates ID 2 of the port in the MSTP process.

PortID3

Indicates ID 3 of the port in the MSTP process.

PortID4

Indicates ID 4 of the port in the MSTP process.

PortIDFlag

Indicates the port flag.

IfIndex

Indicates the port index.

PortState

Indicates the port state.

PortName

Indicates the port name.

Impact on the System

The network topology will change.

Possible Causes

1.

A new link was added to the network topology, and the link status of MSTP process changed.

2.

The network topology changes that the port changes from the Blocked state into the Forwarding state.

Procedure

  1. View physical devices on the network to check whether new physical connections enabled with STP are added.

    • If so, go to Step 2.

    • If not, go to Step 3.

  2. Check whether the added physical link is necessary.

    • If so, go to Step 3.

    • If not, go to Step 4.

  3. Run the display stp [ instance instance-id ] [ interface interface-type interface-number | slot slot-id ] [ brief ] command to check whether the interfaces are consistent with the STP calculation results.

    • If so, go to Step 6.

    • If not, go to Step 5.

  4. Correctly deploy the network topology, and then check whether the alarm is cleared.

    • If the alarm is cleared, go to Step 6.

    • If the alarm is not cleared, go to Step 3.

  5. Collect alarm information and configuration information, and then contact technical support personnel.
  6. End.

Related Information

None.

Translation
Download
Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 156210

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next