No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SECE_1. hwStrackUserInfo

SECE_1. hwStrackUserInfo


SECE/4/STRACKUSER:OID [oid] An attack occurred.(Interface=[OCTET], SourceMAC=[OCTET], InnerVlan=[INTEGER], OuterVlan=[INTEGER], EndTime=[OCTET], TotalPackets=[INTEGER])

The system detected an attack.


Alarm ID Alarm Severity Alarm Type Warning securityServiceOrMechanismViolation(10)


Name Meaning
OID Indicates the ID of the MIB object.
Interface Indicates the access interface of the attacker.
SourceMAC Indicates the source MAC address of packets sent from the attacker.


Indicates the inner VLAN ID of packets sent from the attacker.


Indicates the outer VLAN ID of packets sent from the attacker.
EndTime Indicates the end time of the attack.
TotalPackets Indicates the number of packets received from the attacker.

Impact on the System

The CPU is busy processing attack packets. As a result, normal service packets cannot be processed in time or even discarded.

Possible Causes

The number of packets with the specified MAC address and VLAN ID sent to the CPU exceeded the alarm threshold.


  1. Run the display auto-defend attack-source detail command to check the possible attack source and check whether the system is normal according to the protocol type and packet increase rate.
  2. If the user initiates the attack, configure attack source tracing and set the action taken on attack packets to deny, or configure a traffic policy to discard attack packets.
  3. If the fault cause is unknown, collect alarm, log, and configuration information, and contact technical support personnel.

Related Information


Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 155647

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next