No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
L2IF_1.3.6.1.4.1.2011.5.25.42.3.1.4.4 hwMuxVlanGroupCountExceedThreshold

L2IF_1.3.6.1.4.1.2011.5.25.42.3.1.4.4 hwMuxVlanGroupCountExceedThreshold

Description

L2IF/4/MUXVLAN_COUNT_THRESHOLD: OID [oid] The number of group VLANs of the MUX-VLAN's primary VLAN exceeded the upper threshold. (PrincipalVLANId=[INTEGER], UpperThreshold=[INTEGER])

The number of group VLANs configured in the MUX-VLAN's principal VLAN exceeded the upper threshold.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.42.3.1.4.4 Warning other (1)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

PrincipalVLANId

Principal VLAN ID

UpperThreshold

Upper threshold for the number of group VLANs

Impact on the System

Services will not be affected.

Possible Causes

The number of group VLANs configured in the MUX-VLAN's principal VLAN exceeded the upper threshold.

Procedure

  1. Run the display mux-vlan command to check whether interfaces have been added to the corresponding VLAN, whether interfaces are Up and available and have traffic, and whether all group VLANs are being used. If there is any group VLAN that is not being used, run the undo subordinate group vlan-id1 to [ vlan-id2 ] command in the VLAN view to delete the group VLAN. Check whether the alarm is cleared.

    • If the alarm is cleared, go to Step 3.
    • If the alarm persists, go to Step 2.

  2. Collect alarm information and configuration information, and then contact technical support personnel.
  3. End.
Translation
Download
Updated: 2019-09-24

Document ID: EDOC1000141873

Views: 158067

Downloads: 15

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next