No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R010C00 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, NAC, and Policy Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Quiet Function in 802.1X Authentication

(Optional) Configuring the Quiet Function in 802.1X Authentication

Context

After the quiet function is enabled, when the number of times that a user fails 802.1X authentication reaches the maximum number allowed, the device quiets the user, and during the quiet period, the device discards the 802.1X authentication requests from the user. This prevents the impact of frequent user authentications on the system.

NOTE:

When the number of quiet entries reaches the maximum number, the device does not allow new users who are not in the quiet table to access the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dot1x quiet-period

    The quiet function is enabled.

    By default, the quiet function is enabled.

  3. (Optional) Run dot1x quiet-times fail-times

    The maximum number of authentication failures within 60 seconds before the device quiets the 802.1X authentication user is configured.

    By default, an 802.1X user enters the quiet state after ten authentication failures within 60 seconds.

  4. (Optional) Run dot1x timer quiet-period quiet-period-value

    The quiet timer is set.

    By default, the quiet timer is 60 seconds.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141885

Views: 58516

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next