No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R010C00 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, NAC, and Policy Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NAC Unified Mode

Configuring the NAC Unified Mode

Context

NAC supports the common mode and unified mode. By default, the unified mode is used.

Compared with the common mode, the unified mode uses the modular configuration, making the configuration clearer and configuration model easier to understand.

Considering advantages of the unified mode, you are advised to deploy NAC in unified mode.

NOTE:
  • After the common mode and unified mode are switched, the device automatically restarts, causing service interruption.
  • In the unified mode, only the commands of the common mode are unavailable; in the common mode, only the commands of the unified mode are unavailable. In addition, after the configuration mode is switched, the commands supported by both the common mode and unified mode still take effect.

Procedure

  1. Run display authentication mode

    The current NAC mode is displayed.

    • If the current NAC mode is unified mode, configure the access profile directly.
    • If the current NAC mode is common mode, perform the following steps to switch the NAC mode to unified mode.

  2. Run system-view

    The system view is displayed.

  3. Run authentication unified-mode

    The NAC mode is switched to unified mode.

    By default, the unified mode is used.

Verifying the Configuration

Run the display authentication mode command to check the current NAC configuration mode and the mode after restart.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141885

Views: 55154

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next