No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R010C00 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, NAC, and Policy Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the NAC Open Function in 802.1X Authentication

(Optional) Configuring the NAC Open Function in 802.1X Authentication

Context

After a new NAC network is set up, the network administrator should pay attention to the number of potential access users and authentication method but does not need to control user access, because the administrator needs to configure user names, passwords, and authorization information on the authentication server. After 802.1X or MAC address authentication is configured on the access device, only authenticated users can access the network, so the administrator cannot obtain information about the users who do not have user names and passwords on the authentication server.

The NAC open function allows the users who failed in authentication to access the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Enable the NAC open function in the system view or in the interface view.

    • In the system view:

    1. Run authentication open interface { interface-type interface-number1 [ to interface-number2 ] } &<1-10>

      The NAC open function is enabled.

    • In the interface view:

    1. Run interface interface-type interface-number

      The interface view is displayed.

    2. Run authentication open

      The NAC open function is enabled.

    By default, the NAC open function is disabled on an interface.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141885

Views: 57397

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next