No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S7700 and S9700 V200R010C00

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring USB-based Deployment

Example for Configuring USB-based Deployment

Networking Requirements

To reduce labor costs and save time in device deployment, two new devices need to be automatically upgraded and configured. Requirements for the deployment are as follows:
  • The devices need to be upgraded at 02:09 a.m. on July 28, 2013.
  • The first device S9700 needs to be upgraded from V200R010C00 to a later version, and its MAC address is 0018-0303-1234. This device needs to load the new system software package S9700-new.CC and a user-defined file userfile.txt. After the upgrade, the old system software package needs to be deleted.
  • The second device S9700 needs to be upgraded from V200R010C00 to a later version, and its ESN is 020TEA10A9000016. This device needs to load the new system software package S9700-new.CC, configuration file vrpcfgnew.zip, and path file patch.pat.

Configuration Roadmap

The configuration roadmap is as follows:

  1. Make an index file smart_config.ini.
  2. Save the smart_config.ini file and upgrade files to the root directory of the USB flash drive.
  3. Connect the USB flash drive to a USB port of each device to complete automatic software upgrade.

Procedure

  1. Make an index file.

    # Create an index file and name it smart_config.ini. Add the following content in the index file:

    BEGIN LSW
    [GLOBAL CONFIG]
    TIMESN=20130728.020900
    [DEVICE0 DESCRIPTION]
    MAC=0018-0303-1234
    AUTODELFILE=YES
    DEVICETYPE=S9700
    SYSTEM-SOFTWARE=S9700-new.CC
    SYSTEM-USERDEF1=userfile.txt
    [DEVICE1 DESCRIPTION]
    ESN=020TEA10A9000016
    DEVICETYPE=S9700
    SYSTEM-SOFTWARE=S9700-new.CC
    SYSTEM-CONFIG=vrpcfgnew.zip
    SYSTEM-PAT=patch.pat
    END LSW
    

  2. Save the smart_config.ini file and upgrade files to the root directory of the USB flash drive.
  3. Connect the USB flash drive to the master MPU of the S9700 to start the deployment process. Observe the RUN/ALM indicator on the switch to monitor the deployment state.

    After the switch restarts, the system checks the deployment state. If the RUN/ALM indicator blinks yellow slowly (once every 2s), the USB-based deployment has succeeded. If the RUN/ALM indicator blinks red, the USB-based deployment has failed. View the usbload_error.txt file in the root directory of the USB flash drive to analyze why the deployment fails.

    If the USB-based deployment succeeds, remove the USB flash drive and connect it to the other device.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141895

Views: 51474

Downloads: 208

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next