No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S7700 and S9700 V200R010C00

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Controlling the Display Mode of Commands

Controlling the Display Mode of Commands

Info and warning messages and command execution results are displayed after you run commands on the device. You can control on the display mode of the command outputs.

  • The prompt information and help information can be displayed in Chinese or English. You can use the language-mode { chinese | english } command to switch the language mode. By default, information is displayed in English.

  • When the display output is more than one page, you can use <PageUp> and <PageDown> to display information on the previous page and the next page.

  • When the information cannot be completely displayed on one screen, the system will pause and you can view the information. You can use the function keys listed in Table 1-3 to control the display mode of command lines.

    Table 1-3  Display mode of commands

    Key

    Function

    Ctrl+C or Ctrl+Z

    Stops displaying information and running commands.

    NOTE:

    You can also press any key (the number key, letter key, and so on) except space and Enter.

    Space

    Continues to display the next screen of information.

    Enter

    Continues to display the next line of information.

    The screen-length screen-length temporary command sets the lines to be displayed temporarily on the terminal screen. If screen-length is 0, the split screen function is disabled. Therefore, the system will not pause when the information cannot be completely displayed on one screen.

  • You can not only control the display mode of output information but also control the mode in which a command is displayed on the screen.

    The system supports two command output modes: character mode and line mode, which can be configured using the terminal echo-mode { character | line } command. By default, the character mode is used.

    • character: The command output mode is the character mode. When you enter a character in the command line, the system displays this character.
    • line: The command output mode is the line mode. When you enter a character in the command line, the system displays this character only after you press Enter, Tab or ?.

    When you operate a device using the NMS, you can change the command output mode to line to improve operation efficiency. Common users have a habit of using the character mode. Therefore, use the character mode for common users to improve operation efficiency.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141895

Views: 54645

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next