No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Interface to Insert the Actual MTU into DD Packets

Configuring an Interface to Insert the Actual MTU into DD Packets

Context

The default maximum transmission unit (MTU) is 0.

To improve compatibility with a non-Huawei device, an OSPF-enabled Huawei device adds the MTU 0 in DD packets to be sent and does not check the MTUs in received DD packets, allowing an OSPF neighbor relationship to be set up even if the two ends have different MTU settings.

However, under the default configuration, the non-Huawei device may discard an OSPF packet received from the Huawei device if the packet's actual MTU is greater than the MTU of the non-Huawei device. If the discarded packet is an LSU, an OSPF neighbor relationship can still be set up, but the route carried in the LSU fails to be learned, causing service interruptions.

To resolve this issue, run the ospf mtu-enable command to configure an interface to add the actual MTU in DD packets to be sent and check whether the MTU in a received DD packet is greater than the local MTU. If the interface MTU settings of the local and remote ends are different, an OSPF neighbor relationship cannot enter the Full state. In this manner, MTU inconsistency can then be identified in time.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The OSPF interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    ospf mtu-enable

    The interface is configured to insert the actual MTU into DD packets and check whether the MTU in DD packets from the neighbor exceeds the MTU of the local end.

    By default, the MTU in DD packets sent by an interface is 0.

    Performing this procedure causes the re-establishment of neighbor relationships.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 190357

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next