No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BFD Globally

Configuring BFD Globally

Context

On the two devices that need to establish a BFD session, configure BFD for all the interfaces in a certain OSPFv3 process.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    ospfv3 process-id

    The OSPFv3 view is displayed.

  3. Run:

    bfd all-interfaces enable

    BFD for OSPFv3 is enabled to establish a BFD session.

    By default, BFD is disabled in an OSPFv3 process.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 180295

Downloads: 192

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next