No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration

Prerequisites

The configurations for OSPF attributes on the NBMA network and P2MP network are complete.

Procedure

  • Run either of the following commands to check LSDB information.

    • display ospf [ process-id ] lsdb [ brief ]

    • display ospf [ process-id ] lsdb [ { router | network | summary | asbr | ase | nssa | opaque-link | opaque-area | opaque-as } [ link-state-id ] ] [ originate-router [ advertising-router-id ] | self-originate ] [ age { min-value min-age-value | max-value max-age-value } * ]

  • Run the display ospf [ process-id ] peer [ [ interface-type interface-number ] neighbor-id | brief | last-nbr-down ] command to view neighbor information.
  • Run the display ospf [ process-id ] nexthop command to check next hop information.
  • Run either of the following commands to check routing table information.

    • display ospf [ process-id ] routing [ ip-address [ mask | mask-length ] ] [ interface interface-type interface-number ] [ nexthop nexthop-address ]

    • display ospf [ process-id ] routing router-id [ router-id ]

  • Run the display ospf [ process-id ] interface [ all | interface-type interface-number ] [ verbose ] command to check interface information.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 193813

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next