No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration


All configurations of basic OSPF functions are complete.


  • Run the display ospf [ process-id ] peer command in any view to check information about OSPF neighbors.
  • Run the display ospf [ process-id ] interface command in any view to check information about OSPF interfaces.
  • Run the display ospf [ process-id ] routing command in any view to check information about an OSPF routing table.
  • Run the display ospf [ process-id ] lsdb command to check information in an OSPF LSDB.
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 193237

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next