No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPF Cannot Find Routes of a Non-Local Area

OSPF Cannot Find Routes of a Non-Local Area

Symptom

There are no problems with the link, but OSPF cannot find routes of a non-local area.

Procedure

  1. Check whether the area where the device resides is connected to the backbone area.

    Run the display ospf [ process-id ] brief command on the ABR in the area where the device resides to check area configuration.

    OSPF requires that all non-backbone areas be connected to the backbone area.

    If no backbone area information is configured on the ABR, run the area area-id command in the OSPF view to modify the OSPF area information. Ensure that at least one interface on the ABR runs in the backbone area.

    NOTE:

    If non-backbone areas cannot be connected to the backbone area due to networking restrictions, configure OSPF virtual links to resolve this problem.

  2. Check whether the area where the device resides is a totally stub area.

    Run the display current-configuration configuration ospf [ process-id ] command on the device to check the OSPF process configuration.

    If you specify the parameter no-summary (run the stub no-summary command in the OSPF area view) when configuring a non-backbone area as a stub area on the ABR, the area is configured as a totally stub area.

    A totally stub area allows only intra-area routes to be advertised within the area.

    If the area where the device resides is configured as a totally stub area, perform the following configuration based on service requirements:
    • To restore the totally stub area to a common area, run the undo stub command in the OSPF area view on all devices in the area.

    • To restore a totally stub area to a stub area, run the undo stub command in the OSPF area view on the ABR in the area and then run the stub command.

  3. Check whether the area where the device resides is a totally NSSA.

    Run the display current-configuration configuration ospf [ process-id ] command on the device to check the OSPF process configuration.

    If you specify the parameter no-summary (run the nssa no-summary command in the OSPF area view) when configuring a non-backbone area as an NSSA on the ABR, the area is configured as a totally NSSA.

    A totally NSSA allows only intra-area routes to be advertised within the area.

    If the area where the device resides is configured as a totally NSSA, perform the following configuration based on service requirements:
    • To restore the totally NSSA to a common area, run the undo nssa command in the OSPF area view on all devices in the area.

    • To restore a totally NSSA to a stub area, run the undo nssa command in the OSPF area view on the ABR in the area and then run the nssa command.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 179257

Downloads: 192

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next