No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an OSPFv3 NSSA

Configuring an OSPFv3 NSSA

Applicable Environment

Configure a non-backbone area on the border of an AS as a not-so-stubby area (NSSA) to reduce entries in routing tables and the amount of routing information transmitted. An NSSA allows the transmission of Type 7 LSAs, which are generated by ASBRs in an NSSA. These LSAs are converted into Type 5 LSAs in the NSSA and advertised to other areas.

Pre-configuration Tasks

Before configuring an OSPFv3 NSSA, configure basic OSPFv3 functions.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 181623

Downloads: 192

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next