No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating IPv6 Static Routes

Creating IPv6 Static Routes

Context

When creating IPv6 static routes, you can specify both the outbound interface and next hop. Alternatively, you can specify only the outbound interface or next hop, depending on the interface type:
  • For point-to-point (P2P) interfaces, specify the outbound interface.

  • For non-broadcast multiple access (NBMA) interfaces, specify the next hop.

  • For broadcast interfaces, specify the outbound interface. If the next hop address is also specified, it does not need to be a link-local address.

Specifying the same preference value for IPv6 static routes to the same destination implements load balancing among these routes. Conversely, specifying different preference values for IPv6 static routes to the same destination implements route backup among the routes.

Setting the destination IP address and mask to all 0s configures the default IPv6 static route. By default, no default IPv6 static route is configured.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Configure IPv6 static routes.
    • For public networks, run:

      ipv6 route-static dest-ipv6-address prefix-length { interface-type interface-number [ nexthop-ipv6-address ] | nexthop-ipv6-address | vpn-instance vpn-destination-name nexthop-ipv6-address } [ preference preference | tag tag ] * [ track bfd-session cfg-name ] [ description text ]

      An IPv6 static route is configured on the public network.

    • For VPN instances, run:

      ipv6 route-static vpn-instance vpn-instance-name dest-ipv6-address prefix-length { [ interface-type interface-number ] nexthop-ipv6-address | nexthop-ipv6-address [ public ] | vpn-instance vpn-destination-name nexthop-ipv6-address } [ preference preference | tag tag ] * [ description text ]

      An IPv6 static route is configured on a VPN instance.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 190731

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next