No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPF Attributes on Different Types of Networks

Configuring OSPF Attributes on Different Types of Networks

Applicable Environment

By setting network types for OSPF interfaces and adjusting OSPF attributes, you can flexibly build OSPF networks.

In Table 5-19, OSPF classifies networks into four types based on the types of link layer protocols.

Table 5-19  Network types supported by OSPF

Network Type

Characteristic

Default Configuration

Broadcast

On a broadcast network, Hello packets, LSU packets, and LSAck packets are multicasted; DD packets and LSR packets are unicasted.

If the link layer protocol is Ethernet or Fiber Distributed Data Interface (FDDI), OSPF regards the network as a broadcast network by default.

Non-broadcast multiple access (NBMA)

On an NBMA network, Hello packets, DD packets, LSR packets, LSU packets, and LSAck packets are unicasted.

An NBMA network must be fully meshed. Any two switches on an NBMA network must be directly reachable.

If the link layer protocol is ATM, OSPF regards the network as an NBMA network by default.

Point-to-point (P2P)

On a P2P network, Hello packets, DD packets, LSR packets, LSU packets, and LSAck packets are multicasted.

If the link layer protocol is PPP, HDLC, or Link Access Procedure Balanced (LAPB), OSPF regards the network as a P2P network by default.

Point-to-multipoint (P2MP)

On a P2MP network, Hello packets are multicasted; DD packets, LSR packets, LSU packets, and LSAck packets are unicasted.

OSPF does not regard a network as a P2MP network by default regardless of its link layer protocol. A P2MP network must be forcibly changed from the network of another type.

As described in Table 5-19, the difference between OSPF configurations on networks of different types lies in the packet transmission mode.

Pre-configuration Tasks

Before configuring OSPF attributes on different types of networks, complete the following tasks:

Configuration Procedures

Configuring network types of OSPF interfaces is the prerequisite for configuring P2MP or NBMA network attributes

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 190403

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next