No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring RIP Neighbors on an NBMA Network

(Optional) Configuring RIP Neighbors on an NBMA Network

Context

RIP often uses a broadcast or multicast address to send packets. If the link running RIP does not support broadcast or multicast packets, specify RIP neighbors on both ends of the link. This allows packets to be sent between the two ends in unicast mode.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    rip [ process-id ]

    The RIP view is displayed.

  3. Run:

    peer ip-address

    A RIP neighbor is configured.

    NOTE:

    The device of the current version supports up to 256 RIP neighbors.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 178402

Downloads: 192

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next