No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Route Flapping Occurs on a RIP Network

Route Flapping Occurs on a RIP Network

Fault Description

Route flapping occurs on a RIP network when the link runs properly. Some routes intermittently disappear in the routing table.

Procedure

  1. Run the display rip command to check the configuration of RIP timers.

    The RIP timers on the entire network must be consistent; otherwise, route flapping occurs. The relationships between the timer values are update < age, update < garbage-collect.

  2. Run the timers rip update age garbage-collect command to set the RIP timers.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 180279

Downloads: 192

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next