No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adjusting the BGP Network Convergence Speed

Adjusting the BGP Network Convergence Speed

Pre-configuration Tasks

Before adjusting the BGP network convergence speed, configure basic BGP functions.

Configuration Flowchart

You can perform the following configuration tasks (excluding the task of checking the configuration) in any sequence.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 194299

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next