No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling OSPFv3 GR

Enabling OSPFv3 GR


Perform the following operations on the switch that runs OSPFv3.


  1. Run:


    The system view is displayed.

  2. Run:

    ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run:

    graceful-restart [ period period | ack-time time | retransmit-interval interval | lsa-checking-ignore | planned-only ] *

    OSPFv3 GR is enabled.

    By default, OSPFv3 GR is disabled.

    ack-time is optional. After ack-time is specified, the restarter can discover more neighbors in the ack-time period.

Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 190253

Downloads: 194

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next