No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S7700 and S9700 V200R010C00

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Defining an Area as an NSSA

Defining an Area as an NSSA

Context

Perform the following operations on the switch that runs OSPFv3.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    ospfv3 [ process-id ]

    The OSPFv3 process view is displayed.

  3. (Optical) Run:

    lsa-forwarding-address { standard | zero-translate }

    The OSPFv3 forwarding address (FA) function is enabled.

  4. Run:

    area area-id

    The OSPFv3 area view is displayed.

  5. Run:

    nssa [ default-route-advertise [ cost cost | type type | tag tag ] * | no-import-route | no-summary | translator-always | translator-interval translator-interval | set-n-bit | suppress-forwarding-address  ] *

    An area is configured as an NSSA.

Follow-up Procedure

If an area is configured as an NSSA, all switches in the area must be configured with the NSSA attribute.

The area may be updated after NSSA attributes are configured or deleted. Therefore, the NSSA attributes can be re-configured or deleted only after the last update to the area is complete.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141900

Views: 181978

Downloads: 192

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next