No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Interface Management

S7700 and S9700 V200R010C00

This document describes the principles and configurations of interfaces and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Loopback Interface

Configuring a Loopback Interface

Context

A loopback interface has the following features:

  • Is always Up and has the loopback feature.
  • Can be configured with the mask of all 1s.

Based on the preceding features, the loopback interface has the following applications.

  • The IP address of a loopback interface is specified as the source address of packets to improve network reliability.
  • When no Router ID is configured for dynamic routing protocols, the maximum IP address of the loopback interface is automatically configured as the router ID.
  • The loopback interface is configured as the source interface to send boarder gateway protocol (BGP) packets to ensure that the BGP session functions properly when the physical interface is faulty.
  • The loopback interface can be configured with the mask of 255.255.255.255 to save IP address resources.
  • The loopback interface can be assigned an IPv4 address, bound to a VPN instance, and configured to check the source IPv4 addresses of packets.

Pre-Configuration

Before configuring a loopback interface, power on the device and perform self-check.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface loopback loopback-number

    A loopback interface is created and the loopback interface view is displayed.

    You can create or delete a loopback interface dynamically. After a loopback interface is created, the link-layer protocol is always Up unless the loopback interface is deleted.

  3. (Optional) Run:

    ip binding vpn-instance vpn-instance-name

    The loopback interface is bound to the VPN instance.

  4. Run:

    ip address ip-address { mask | mask-length } [ sub ]

    The IP address of the loopback interface is configured.

  5. (Optional) Run:

    ip verify source-address

    The loopback interface is configured to check the source IPv4 addresses of packets.

Checking the Configuration

  • Run the display interface loopback [ loopback-number ] command to check the status of a loopback interface.
Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141901

Views: 18675

Downloads: 79

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next