No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Interface Management

S7700 and S9700 V200R010C00

This document describes the principles and configurations of interfaces and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Can an IP Address Be Directly Assigned to a Physical Interface?

Can an IP Address Be Directly Assigned to a Physical Interface?

An Eth management port is a Layer 3 interface. You can directly configure an IP address for the interface.

To configure an IP address for a service interface, configure a VLANIF virtual interface, and assign an IP address to the VLANIF interface. Example:

<HUAWEI> system-view
[HUAWEI] vlan 10 
[HUAWEI-vlan10] quit  
[HUAWEI] interface vlanif 10 
[HUAWEI-Vlanif10] ip address 192.168.1.10 24 

You can also configure an IP address on a sub-interface of a service interface.

In V200R005C00 and later versions, run the undo portswitch command changes the working mode of Ethernet interfaces from Layer 2 mode to Layer 3 mode. Ethernet interfaces working at Layer 3 support IP address configuration.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141901

Views: 18587

Downloads: 79

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next