No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the PHP Feature

(Optional) Configuring the PHP Feature

Context

No label needs to be swapped on the egress node of an LSP. PHP can be configured on the egress node to allow the LSR at the penultimate hop to pop out the label from an MPLS packet and send the packet to the egress node. After receiving the packet, the egress node directly forwards the packet through an IP link or according to the next layer label. PHP helps reduce the burden on the egress node.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    mpls

    The MPLS view is displayed.

  3. Run:

    label advertise { explicit-null | implicit-null | non-null }

    The label allocated to the LSR at the penultimate hop is configured.

    The egress node can allocate different labels to the PHP based on the parameter setting.

    • implicit-null: default value, which indicates that PHP is supported. If this parameter is configured, the egress node allocates an implicit null label with the value of 3 to the LSR at the penultimate hop.

    • explicit-null: PHP is not supported. If this parameter is configured, the egress node allocates an explicit null label with the value of 0 to the LSR at the penultimate hop.The explicit-null parameter can be configured when MPLS QoS attributes are used.

    • non-null: PHP is not supported. If this parameter is configured, the egress allocates a common label with a value greater than or equal to 16 to the LSR at the penultimate hop.

    NOTE:

    After the label advertise command is run to change the label distribution mode on the egress node, the modification takes effect on new LSPs but not on existing LSPs. To enable the modification to take effect on the existing LSPs, run the reset mpls ldp or lsp-trigger command.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 70025

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next