No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Adjusting BFD Parameters

(Optional) Adjusting BFD Parameters


BFD parameters include the minimum intervals for sending and receiving BFD packets, and local BFD detection multiplier. The parameters affect BFD session setup.

You can adjust the local detection time according to the network situation. On an unstable link, if a small detection time is used, a BFD session may flap. You can increase the detection time of the BFD session. If the MPU has the ES0D00FSUA00 card installed or the MPU is EH1D2SRUDC00/EH1D2SRUDC01, you are advised to use the interval of 20 ms, 50 ms, 100 ms, 300 ms, 500 ms, or 1000 ms.


Actual interval for the local device to send BFD packets = MAX {locally configured interval for sending BFD packets, remotely configured interval for receiving BFD packets}

Actual interval for the local device to receive BFD packets = MAX {remotely configured interval for sending BFD packets, locally configured interval for receiving BFD packets}

Local detection time = Actual interval for receiving BFD packets x Remotely configured BFD detection multiplier

Perform the following steps on the ingress node.


  1. Run:


    The system view is displayed.

  2. Run:


    The BFD view is displayed.

  3. Run:

    mpls ping interval interval

    The interval for sending LSP ping packets is adjusted.

    By default, the interval at which LSP ping packets are sent in a dynamic BFD session is 60 seconds.

  4. Run:


    Exit from the BFD view.

  5. Run:


    The MPLS view is displayed.

  6. Run:

    mpls bfd { min-tx-interval tx-interval | min-rx-interval rx-interval | detect-multiplier multiplier }*

    BFD time parameters are set.

Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69328

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next