No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between TE FRR and CR-LSP Backup

Configuring Association Between TE FRR and CR-LSP Backup

Pre-configuration Tasks

After the primary CR-LSP is faulty, the system starts the TE FRR bypass tunnel and tries to restore the primary CR-LSP the same time it sets up a backup CR-LSP.

Before configuring association between TE FRR and CR-LSP backup, complete the following tasks:

Context

Association between TE FRR and CR-LSP backup protects the entire CR-LSP.

Perform the following configurations on the ingress node of the primary MPLS TE tunnel.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel interface-number

    The tunnel interface view of the MPLS TE tunnel is displayed.

  3. Run:

    mpls te backup frr-in-use

    When the primary CR-LSP is faulty (that is, the primary CR-LSP is in FRR-in-use state), the system starts the bypass CR-LSP and tries to restore the primary CR-LSP. At the same time, the system attempts to set up a backup CR-LSP.

  4. Run:

    mpls te commit

    The tunnel configurations are committed.

Checking the Configuration

Run the display mpls te tunnel-interface [ tunnel interface-number | auto-bypass-tunnel [ tunnel-name ] ] command to view information about the tunnel.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69811

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next