No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RSVP Hello Extension

Configuring RSVP Hello Extension

Context

The RSVP Hello extension mechanism is used to fast detect reachability of RSVP neighbors. When the mechanism detects that a neighboring RSVP node is unreachable, the MPLS TE tunnel is torn down.

NOTE:

For details about the RSVP Hello extension mechanism, see RFC 3209.

Perform the following configurations on each node of the MPLS TE tunnel.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    mpls

    The MPLS view is displayed.

  3. Run:

    mpls rsvp-te hello

    RSVP Hello extension function is enabled on this node.

    By default, the RSVP hello extension is disabled.

  4. Run:

    mpls rsvp-te hello-lost times

    The permitted maximum number of dropped Hello messages is set.

    When the RSVP Hello extension is enabled, by default, Hello ACK messages cannot be received for consecutive three times, exceeding which the link is regarded as faulty, and the TE tunnel is torn down.

  5. Run:

    mpls rsvp-te timer hello interval

    The interval for sending Hello messages is set.

    When the RSVP Hello extension is enabled, by default, the interval of Hello message is 3 seconds.

    If the interval is modified, the modification takes effect after the timer expires.

  6. Run:

    quit

    Return to the system view.

  7. Run:

    interface interface-type interface-number

    The interface view of the RSVP-TE-enabled interface is displayed.

  8. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  9. Run:

    mpls rsvp-te hello

    The RSVP Hello extension function is enabled on the interface.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69944

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next