No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration

Prerequisites

The configurations of manual TE FRR are complete.

Procedure

  • Run the display mpls lsp lsp-id ingress-lsr-id session-id lsp-id [ verbose ] command to check information about a specified primary tunnel.
  • Run the display mpls lsp attribute bypass-inuse { inuse | not-exists | exists-not-used } command to check information about the attribute of a specified bypass LSP.
  • Run the display mpls lsp attribute bypass-tunnel tunnel-name command to check information about the attribute of a bypass tunnel.
  • Run the display mpls te tunnel-interface [ tunnel interface-number | auto-bypass-tunnel [ tunnel-name ] ] command to check detailed information about the tunnel interface of a specified primary or bypass tunnel.
  • Run the display mpls te tunnel path [ [ [ tunnel-name ] tunnel-name ] [ lsp-id ingress-lsr-id session-id lsp-id ] | fast-reroute { local-protection-available | local-protection-inuse } | lsr-role { ingress | transit | egress } ] command to check information about paths of a specified primary or bypass tunnel.
  • Run the display mpls rsvp-te statistics fast-reroute command to check TE FRR statistics.
  • Run the display mpls stale-interface [ interface-index ] [ verbose ] command to check the information about MPLS interfaces in the Stale state.
Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69466

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next