No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD for Static LSPs

Configuring Static BFD for Static LSPs

Context

When configuring static BFD for static LSPs, pay attention to the following points:

  • A static BFD session can be created for non-host routes. When the static LSP becomes Down, the associated BFD session also becomes Down. When the static LSP goes Up, a BFD session is reestablished.

  • The forwarding modes on the forwarding path and reverse path can be different (for example, an IP packet is sent from the source to the destination through an LSP, and is sent from the destination to the source in IP forwarding mode), but the forwarding path and reverse path must be established over the same link. If they use different links, BFD cannot identify the faulty path when a fault is detected.

By configuring static BFD for static LSPs, you can check connectivity of static LSPs.

Pre-configuration Tasks

Before configuring static BFD for static LSP, create static LSPs. For details, see Creating Static LSPs.

Configuration Process

Configure static BFD for static LSPs according to the following sequence.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 70275

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next