No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an LDP Label Advertisement Mode

(Optional) Configuring an LDP Label Advertisement Mode

Context

By default, a downstream node sends Label Mapping messages to its upstream node. When faults occur on the network, services can be fast switched to the standby path, improving network reliability. Edge devices on the MPLS network are low-end devices. To ensure network reliability, resources must be fully used. You can configure the Downstream on Demand (DoD) mode to save system resources. In DoD mode, the downstream LSR sends a Label Mapping message to the upstream LSR only when the upstream LSR sends a Label Request message to the downstream LSR.

  • Modifying a configured label advertisement mode leads to the reestablishment of an LDP session, resulting in MPLS service interruption.

NOTE:
  • When the local and remote LDP sessions coexist, they must be configured with the same label advertisement mode.

Procedure

  • Configuring an LDP label advertisement mode of local LDP session.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run:

      mpls ldp advertisement { dod | du }

      A label advertisement mode is configured.

      By default, the label advertisement mode is downstream unsolicited (DU).

      Inconsistency in label advertisement modes leads to failure in establishing LDP LSPs between the two LDP peers over multiple links.

  • Configuring an LDP label advertisement mode of remote LDP session.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      mpls ldp remote-peer remote-peer-name

      A remote MPLS LDP peer is created and the remote MPLS LDP peer view is displayed.

    3. Run:

      mpls ldp advertisement { dod | du }

      A label advertisement mode is configured.

      By default, the label advertisement mode is downstream unsolicited (DU).

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69993

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next