No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Best-Effort Path

(Optional) Configuring a Best-Effort Path

Context

A best-effort path is configured on the ingress node of a primary CR-LSP to take over traffic if both the primary and backup CR-LSPs fail.

Perform the following configurations on the ingress node of an MPLS TE tunnel.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel tunnel-number

    The tunnel interface view is displayed.

  3. Run:

    mpls te backup ordinary best-effort

    A best-effort path is configured.

    NOTE:

    A tunnel interface cannot be used for both a best-effort path and a manually configured ordinary backup tunnel. A protection failure will occur if the mpls te backup ordinary best-effort and mpls te backup ordinary commands are run on the tunnel interface.

    To establish a best-effort path over a specified path, run either or both of step 4 and step 5.

  4. (Optional) Run:

    mpls te affinity property properties [ mask mask-value ] best-effort

    The affinity property of the best-effort path is configured.

    By default, the affinity property used by the best-effort path is 0x0 and the mask is 0x0.

  5. (Optional) Run:

    mpls te hop-limit hop-limit-value best-effort

    The hop limit of the best-effort path is set.

    The default hop limit is 32.

  6. Run:

    mpls te commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 70273

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next