No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing MPLS OAM Performance Statistics

Clearing MPLS OAM Performance Statistics

Context

Before monitoring MPLS OAM performance, you are advised to clear the MPLS OAM statistics.

MPLS OAM statistics cannot be restored after being cleared. Therefore, exercise caution when you use the following commands.

Procedure

  • To clear statistics about MPLS OAM packets on the ingress, run the reset mpls oam packet-statistics ingress { all | Tunnel interface-number } command.
  • To clear statistics about MPLS OAM packets on the egress, run the reset mpls oam packet-statistics egress { all | lsp-name lsp-name | lsr-id egress-lsr-id tunnel-id tunnel-id } command.
  • To clear statistics about all MPLS OAM packets, run the reset mpls oam packet-statistics global command.
Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 70312

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next