No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Tunnel Priority

Configuring the Tunnel Priority


In the process of establishing a CR-LSP, if no path with the required bandwidth exists, you can perform bandwidth preemption according to setup priorities and holding priorities.

Perform the following configurations on the ingress node of an MPLS TE tunnel.


  1. Run:


    The system view is displayed.

  2. Run:

    interface tunnel interface-number

    The tunnel interface view of the MPLS TE tunnel is displayed.

  3. Run:

    mpls te priority setup-priority [ hold-priority ]

    The priority for the tunnel is configured.

    Both the setup priority and the holding priority range from 0 to 7. The smaller the value is, the higher the priority is.

    By default, both the setup priority and the holding priority are 7. If only the setup priority value is set, the holding priority value is the same as the setup priority value.


    The setup priority should not be higher than the holding priority. So the value of the setup priority must not be less than that of the holding priority.

  4. Run:

    mpls te commit

    The current tunnel configuration is committed.

Updated: 2019-08-21

Document ID: EDOC1000141902

Views: 73384

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next