No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Non-labeled Public Network Routes to Be Iterated to LSPs

Configuring Non-labeled Public Network Routes to Be Iterated to LSPs

Pre-configuration Tasks

By default, non-labeled public network routes can be iterated to outgoing interfaces and next hops, but cannot be iterated to tunnels. After this feature is configured, non-labeled public network routes can be iterated to LSPs.

Before configuring non-labeled public network routes to be iterated to LSPs, complete the following tasks:

  • Configure a local LDP session. For details, see Configuring Basic Functions of MPLS LDP.

  • Configure an IP prefix list if non-labeled public network routes to be iterated to LSPs need to be limited.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    route recursive-lookup tunnel [ only ] [ ip-prefix ip-prefix-name ]

    The non-label public network route is allowed to be iterated to the LSP to forward through MPLS.

    By default, the non-label public network route can be iterated only to the outbound interface and the next hop but not the LSP tunnel.

    If ip-prefix ip-prefix-name is not set, all static routes and non-labeled public BGP routes will be preferentially iterated to LSP tunnels.

Checking the Configuration

After non-labeled public routes are iterated to LSPs, you can run the display bgp routing-table network command to view route iteration information.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69674

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next