No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring MPLS OAM Operations

Monitoring MPLS OAM Operations

Context

As a routine maintenance procedure, you can run the following commands in any view to check the status of MPLS OAM operations.

Procedure

  • Run the display mpls oam egress { all | lsp-name lsp-name | lsr-id ingress-lsr-id tunnel-id tunnel-id } [ verbose ] command to view information about the current status and configuration of the OAM-enabled LSP on the egress.
  • Run the display mpls oam egress receive-packet { all | ap-fdi | cv | error | fdi | ffd } command to view statistics about the OAM packets received over the OAM-enabled LSP on the egress.
  • Run the display mpls oam egress send-packet { all | bdi | error } command to view statistics about the OAM packets sent over the OAM-enabled LSP on the egress.
  • Run the display mpls oam ingress { all | tunnel interface-number } [ verbose ] command to view information about the MPLS OAM parameters and status of the LSP on the ingress.
  • Run the display mpls oam ingress receive-packet { all | bdi | error } command to view statistics about the OAM packets received over the OAM-enabled LSP on the ingress.
  • Run the display mpls oam ingress send-packet { all | ap-fdi | cv | error | ffd } command to view statistics about the OAM packets sent over the OAM-enabled LSP on the ingress.
  • Run the display mpls oam oam-index index-value command to view information about the parameters and status of MPLS OAM.
Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69625

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next