No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Link Bandwidth

(Optional) Configuring Link Bandwidth


When a non-Huawei device as the ingress node of an MPLS TE tunnel initiates a request for setting up a CR-LSP with bandwidth constraints, configure link bandwidth on the connected Huawei device for negotiation so that the CR-LSP can be set up and network resources are used efficiently.


The configured bandwidth takes effect only during tunnel establishment and protocol negotiation, and does not limit the bandwidth for traffic forwarding. (The X1E series cards do not have this restriction.)

Perform the following configurations on each node of the MPLS TE tunnel.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The MPLS-TE-enabled interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    mpls te bandwidth max-reservable-bandwidth bw-value

    The maximum available bandwidth of the link is configured.

    By default, the maximum reservable bandwidth of a link is 0 bit/s. The bandwidth allocated to a static CR-LSP built over a link is certainly higher than 0 bit/s. If the maximum reservable bandwidth of the link is not configured, the static CR-LSP cannot be set up due to insufficient bandwidth.

  5. Run:

    mpls te bandwidth { bc0 bc0-bw-value | bc1 bc1-bw-value } *

    The BC bandwidth of the link is configured.

    • The maximum reservable bandwidth of a link cannot be greater than the actual bandwidth of the link. A maximum of 80% of the actual bandwidth of the link is recommended for the maximum reservable bandwidth of the link.
    • Neither the BC0 bandwidth nor the BC1 bandwidth can be greater than the maximum reservable bandwidth of the link.

Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69178

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next