No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Static MPLS TE Tunnel

Configuring a Static MPLS TE Tunnel

Pre-configuration Tasks

Configuring a static MPLS TE tunnel can implement setup of static CR-LSPs. The configuration is simple. Labels are allocated manually and control packets do not need to be exchanged, so static LSPs consume less resources.

Before configuring a static MPLS TE tunnel, complete the following tasks:

  • Configure an LSR ID on each LSR.

  • Enable basic MPLS functions on each LSR globally and on each interface.

NOTE:

After a static CR-LSP is bound to a tunnel interface, the static CR-LSP takes effect without an IP route configured.

Configuration Process

Except that configuring link bandwidth is optional, all the other configurations are mandatory.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69818

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next