No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LDP LSP Alternates Between Up and Down States

LDP LSP Alternates Between Up and Down States

Fault Description

An LDP LSP alternates between Up and Down states after being established.

Procedure

  • Check whether the LDP session flaps.

    Run the display mpls ldp session command to check the displayed Status field. You are advised to run this command once every 1s. If the LDP session status switches between Operational and non-operational, the LDP session flap occurs.

    If the LDP session flap occurs, rectify the fault by referring to LDP Session Alternates Between Up and Down States.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 70189

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next