No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Re-optimization for CR-LSP

Configuring Re-optimization for CR-LSP

Context

By configuring the tunnel re-optimization function, you can periodically recompute routes for a CR-LSP. If the recomputed routes are better than the routes in use, a new CR-LSP is then established according to the recomputed routes. In addition, services are switched to the new CR-LSP, and the previous CR-LSP is deleted.

If an upstream node on an MPLS network is busy but its downstream node is idle or an upstream node is idle but its downstream node is busy, a CR-LSP may be torn down before the new CR-LSP is established, causing a temporary traffic interruption. In this case, you can configure the switching and deletion delays.

NOTE:
  • If the re-optimization is enabled, the route pinning cannot be used at the same time.

  • The CR-LSP re-optimization cannot be configured when the resource reservation style is FF.

Perform the following configurations on the ingress node of an MPLS TE tunnel.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel interface-number

    The tunnel interface view of the MPLS TE tunnel is displayed.

  3. Run:

    mpls te reoptimization [ frequency interval ]

    Periodic re-optimization is enabled.

    By default, re-optimization is disabled. The default periodic re-optimization interval is 3600 seconds.

  4. Run:

    mpls te commit

    The current tunnel configuration is committed.

  5. Run:

    quit

    The system view is displayed.

  6. (Optional) Set the switching and deletion delays.

    1. Run:

      mpls

      The MPLS view is displayed.

    2. Run:

      mpls te switch-delay switch-time delete-delay delete-time

      The switching and deletion delays are set.

      By default, the switching delay is 5000 ms and the deletion delay is 7000 ms.

  7. Run:

    return

    Back to the user view.

  8. (Optional) Run:

    mpls te reoptimization [ tunnel interface-number ]

    Manual re-optimization is enabled.

    After you configure the automatic re-optimization in the tunnel interface view, you can return to the user view and run the mpls te reoptimization command to immediately re-optimize all tunnels or the specified tunnel on which the automatic re-optimization is enabled. After you perform the manual re-optimization, the timer of the automatic re-optimization is reset and counts again.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 70104

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next