No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration


The configurations of adjusting the path of a CR-LSP are complete.


  • Run the display mpls te tunnel verbose command to check information about the MPLS TE tunnel.
  • Run the display mpls te srlg { srlg-number | all } command to check the SRLG configuration and interfaces in the SRLG.
  • Run the display mpls te link-administration srlg-information [ interface interface-type interface-number ] command to check the SRLG that interfaces belong to.
  • Run the display mpls te tunnel c-hop [ tunnel-name ] [ lsp-id ingress-lsr-id session-id lsp-id ] command to check path computation results of tunnels.
  • Run the display default-parameter mpls te cspf command to check default CSPF settings.
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69954

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next