No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R010C00

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Pinning

Configuring Route Pinning

Context

By configuring the route pinning function, you can use the path that is originally selected, rather than another eligible path, to set up a CR-LSP.

Perform the following configurations on the ingress node of an MPLS TE tunnel.

NOTE:

If route pinning is enabled, the MPLS TE re-optimization cannot be used at the same time.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface tunnel interface-number

    The tunnel interface view of the MPLS TE tunnel is displayed.

  3. Run:

    mpls te route-pinning

    Route pinning is enabled.

    By default, route pinning is disabled.

  4. Run:

    mpls te commit

    The current tunnel configuration is committed.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141902

Views: 69308

Downloads: 189

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next