No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Task Summary

Configuration Task Summary

Table 16-1 describes multicast network management configuration tasks.

Table 16-1  Multicast network management configuration tasks

Task

Description

Configuring Basic Multicast Network Management Functions
After multicast network management is enabled, you can bind multicast MIBs to the public network instance and enable trap of a specified module. The switch then monitors events of the specified protocol. Currently, the switch supports the following multicast MIBs:
  • Internet Group Management Protocol (IGMP)
  • Multicast Listener Discovery (MLD)
  • Multicast Route Management (MRM)
  • PIM (IPv4 and IPv6)
  • Multicast Source Discovery Protocol (MSDP)
  • Layer 2 multicast
Adjusting the Frequency of Multicast Protocol Trap Messages

By setting the interval at which a multicast protocol sends trap messages, you can monitor events of the multicast protocol in a timely manner.

Configuring the Upper and Lower Alarm Thresholds for Multicast Protocol Entries

After you set thresholds for various multicast protocol entries, the switch will report a threshold crossing event when the number of multicast protocol entries reaches a specified value.

Configuring Alarm Thresholds for Multicast Index Usage

After setting the alarm threshold of the multicast index usage, you can learn the multicast index usage in a timely manner. This prevents multicast service failures caused by index resource exhaustion.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 147605

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next