No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
There Is No (S, G) Entry in the SA Cache

There Is No (S, G) Entry in the SA Cache

Fault Description

No (S, G) entries are sent to an MSDP peer through Source-Active (SA) messages.

Fault Analysis

  • The import-source command filters the (S, G) entries sent from a local domain to the remote MSDP peer through SA messages. If acl is not specified in the command, the switch filters out all the (S, G) entries.
  • If the import-source command is not configured, the switch sends all (S, G) entries in the local domain to the remote peer. When MSDP fails to send (S, G) entries in the local domain through SA messages, check whether the import-source command has been configured correctly.

Procedure

  1. Check whether the two MSDP peers have learned ARP entries from each other.

    Run the display arp all command to check ARP entries on the two devices.

  2. Check whether the two devices have reachable unicast routes to each other.

    Run the display ip routing-table command to check routing tables of the two MSDP peers.

  3. Check whether the interface addresses used to set up MSDP peer relationships are correct.

    Run the display current-configuration command to check whether the local interface address is the same as the remote MSDP peer address configured on the remote device.

  4. Check whether any SA message filtering rules are configured.

    Run the display this command in the MSDP view to check whether import-source is configured with a specified ACL that filters (S, G) information.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 152976

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next